Sign in to follow this  
Followers 0

Spare Clutch Cable


tomatocity

Before your current clutch cable breaks, purchase a new clutch cable and install it next to the current, now spare, clutch cable.

Leave the spare clutch cable in place. Lightly lube the spare clutch cable. Seal the ends of the spare clutch cable with shrink wrap or another method you think of.

If you break a clutch cable while you are on the road you are just 15-20 minutes away from being back on the road. This will keep you from terrorizing your transmission with clutchless shifts.


Sign in to follow this  
Followers 0


User Feedback


There are no comments to display.



Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:


  • Similar Content

    • By LuizSNeto
      SUB Mount / Complete Stabilizer Kit / when using stock triple clamps   
      (P/N: DS-SUB-7330-01)
       
      Photo may not be your exact model but depicts the same mounting configuration. This kit is designed to be used with the stock Triple clamps and over-sized handlebars. If your model comes with std diameter bars, you'll need to change to oversize bars or use our "Bar reducers", both available here online. We've machined this SUB mount to give you 2 possible handlebar mounting positions. Position 1 is stock, position 2 is 10mm forward of the stock bar position. Step by step pictured instructions are included along with all the necessary hardware.

      "SUB" mount stands for Stabilizer Under Bars, originally designed for raising the bars. These kits are designed for use with Oversize bars. "Bar reducers" are available as an option, to convert the kit to standard diameter bars, should that be desired. This concept allows more room for other equipment such as, Global Positioning Systems(GPS) or Enduro/Rally computers and yet still retain the quick access for adjusting the stabilizer. This is also good for the taller rider who wants his bars a little higher, as it raises the bar location approximately 11-25mm, depending on the model of bike. In some cases, you might consider a lower bend handlebar bend at the same time, unless you are trying to achieve a higher bar height along with your stabilizer installation. We can also help you with other handlebar choices to match your desired setup, as we have a full selection of handlebars to choose from on this website. The SUB mounts are only available on certain models based on the physical limitations of mounting in this area. Each SUB mount comes complete with all necessary parts, hardware and "Step by Step" pictured instructions. If you have any questions, feel free to call or email us. The Photo attached here may be a generic photo to show you the basic components in the kit, but may not be showing the exact kit for your specific bike.
    • By LuizSNeto
      Product Code: LV-120
       
      Gen2 Direct-fit IntelliLever Clutch Blade
      Replaces OE Clutch Lever 50302031300
      Not compatible with KTM OE Handguards
    • By LuizSNeto
      Part Number : LV-112
       
      Gen2 IntelliLever
      Front Brake Lever for
      KX125/250/250F/450F 2000-12
      RM/RM-Z125/250/450 1996-16
      YZ/YZF125/250/426/450 2001-07 (Except YZF250 2007)
      WR250F 2001-2013
      WR450F 2003-2010
    • By LuizSNeto
      For the lovers of foam, our foam grips are the best for comfort, less vibration and lighness.

      Used on most of Dakar bikes and other rally races bikes.

      On the desert races are still the grateset grips.

      Open end only
      Made in Italy
      Size: Ø mm 22-25 / Long mm 125
    • By LuizSNeto
      Hymec Hidraulic Clutch for Yamaha WR 450F 03-11