Threadlocking User's Guide

I thought this week it would be a good idea to share with you an example of what can happen when dirt gets passed an engine's air filter. This will be a short post, but a picture is worth a thousand words. In my next post I’ll go into detail on how to properly care for your air filter to help ensure that this never happens to you.
 
The series of photos below shows a sad case where dirt has found its way into the engine and wreaked havoc. The photos are all from the KX250F I bought on the cheap with the sole intention of rebuilding the engine and documenting the process for my book, The Four Stroke Dirt Bike Engine Building Handbook. Honestly, I couldn’t have bought a better bike for the project, nearly everything on the bike was worn out or screwed up from the previous owner.
 
Here is how the air filter and airbox looked prior to disassembly.

 
Here is the back side of the air filter. The filter was completely dry. There was no grease on the sealing face of the filter or the airbox flange. In this particular case, dirt could have got into the engine through the filter or between the filter and sealing flange. The amount of dried mud in the airbox and on the bike also makes me suspicious that muddy water got into the engine instead of just dirt. I honestly can’t say for certain.
 

 
The airbox itself was also extremely dirty.
 

 
Once the engine was disassembled I carefully examined the piston assembly and cylinder bore. At first, I could not get any of the rings to move freely. Only after I had pounded a pick between the ring ends of the compression ring was I able to get the compression ring off. As I removed the compression ring, a load of sand came with it.
 
This photo of the compression ring doesn’t do the situation justice. Some of the dirt was actually removed from the ring as I handled it.

 
Here is a close up of the compression ring. Note all the grit!
 


 
The oil rings didn’t fair any better, were just as stuck, and had a lot of dirt on them.
 


 
Here you can see dirt inside the ring grooves and at the edges.
 


 
Here is dirt I rubbed off the oil rings.
 

 
Miraculously (and fortunately for me) whether the engine sucked in dirty air or water, it happened quickly and stuck the rings to the piston so they could no longer seal correctly, and the engine subsequently lost compression and power in a hurry. This speculation is based on the fact that the cylinder bore showed no signs of excessive wear or damage and it measured well within the service limits. This is an outcome I never though possible and is hard to believe.
 
I hope you enjoyed this brief write up on the damage that can result from ingesting dirt, whether from abnormal circumstances such as dropping a running engine into a mud hole or simply neglecting to take care of the air filter when running the engine in dusty conditions. In my next post I’ll show you how to care for and install your filters so these problems don’t happen to you! Questions or comments are always welcome and I enjoy hearing from you all!
 
-Paul
https://www.diymotofix.com/
 
If you like my blog, click the "Follow this blog" button in the upper right. You must be registered to do this.

Keep your foam filter in like-new condition
BIO Liquid Power filter oil was developed and produced by Texaco exclusively for Twin Air; exceeds the strictest standards on biodegradability by 16%; starts thin for deep, even penetration and dries to an even-coating, high-tack shield that traps dirt, dust and grit
BIO Dirt Remover cleans Liquid Bio Power oil by using granular detergents instead of solvents; water-soluble cleaner can go right down the drain without clogging the drain or harming the environment; will not harden or damage filter foam
Recommended for all foam filters
Kit contains one BIO Dirt Remover and one liter liquid BIO Power Filter oil
BIO Dirt Remover in 1 liter bottle, BIO Liquid Power filter oil in 1 liter can or 500ml spray can

Fresh, clean scented silicone detailer restores the factory shine
Excellent for use as a polish, undercoat protectant and light lubricant
Repels water and dries completely

Slick Snow Cleaning Kit contains the essentials to achieve a maximum cleaning experience on any snow vehicles. This package offers a simple process, that will safely and effectively clean off all salt, dust, and dirt, target heavy grease and grime, and leave the vehicle with a waterproof, high gloss coating helping to prevent corrosion. In addition, this package offers added tools to apply solution and assist in the cleaning process.

Slick Street Cleaning Kit contains the essentials to achieve a maximum cleaning experience on any street vehicles. This package offers a simple process that will safely and effectively clean off all salt, dust and dirt, target heavy grease and grime, and leave the vehicle with a waterproof, high gloss coating helping to prevent corrosion. In addition, this package offers added tools to apply the solution and assist in the cleaning process.