Jump to content
Sign in to follow this  

MR250

Recommended Posts

Rebuilt the top end with a bore and new piston etc. bike runs good except starts missing around mid and then to being wound out. New points, tried different coils but it will not run with a new replacement coil from re-mx. re-did bike wiring but not from the stator out wire> I did not check the off switch but the missing is pretty consistent above the same rpm in any gear. set the point gap with an ohm meter.

any ideas.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...