Jump to content
Sign in to follow this  

Rear wheel collar problem

Recommended Posts

Got a question, I just bought new rear wheel bearings for my 2003 yz85. Got the old ones out and one new bearing in but when I go to slide the collar back into the hub, it is now to long and preventing me from getting the other bearing back in.. I'm stumped.. Anybody got any clue why this is happening? The bearings are the correct ones to, and I have the gaskets on the outsides of the bearings.

Share this post


Link to post
Share on other sites

First guess is to say that the bearings are not set deep enough.  You need to install them until the sit tight on the lip inside the hub.  Any way you could send us a pic?

Share this post


Link to post
Share on other sites

Check ID, OD and width against old bearings. If the match Probly not seated all the way

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×