Jump to content
Sign in to follow this  

Shortening width on Renthal Cr High Bend

Recommended Posts

Just changed from factory Renthal to the Cr High Bend and they seem a lil wide. I've never cut any bars off. Are there any disadvantages or things that I need watch for if I decide to do it?

Share this post


Link to post
Share on other sites

They are wide!!! But, I like them like that.... to each his own. Figure out where YOU are comfortable, measure twice, make sure you take off what you want EVENLY from both sides, and make the cut straight! Good luck!

Edited by motoxguy7

Share this post


Link to post
Share on other sites

Measure twice!! Chop saw is great hack saw will take two months...get it str8 not all crooked ...deburr sharp edges left over might save you a trip to er for stitches some day

Share this post


Link to post
Share on other sites

I have access to a chop saw. Probably going to take about 1" off. Don't jinx me on the Er. That's the last place I wanna go visit!

Share this post


Link to post
Share on other sites

I have access to a chop saw. Probably going to take about 1" off. Don't jinx me on the Er. That's the last place I wanna go visit!

Start with a half inch off each side ..you can always remove material if still to long

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×