Jump to content
Sign in to follow this  

Rotor mounting bolts/nuts

Recommended Posts

I would make sure they're hardened. If you can get Class 10.9 flat head cap screws at the hardware store then those should be fine. The nuts are low profile lock nuts though. Probably not something you will find at the hardware store.

 

I will get back to you on size...

Share this post


Link to post
Share on other sites

M8 x 32mm with a flat washer and the low profile lock nut.

 

The low profile nuts are't a necessity on the 400, I was thinking of my CR wheels. With a standard lock nut I'd go with 35mm long bolts.

Share this post


Link to post
Share on other sites

M8 x 32mm with a flat washer and the low profile lock nut.

 

The low profile nuts are't a necessity on the 400, I was thinking of my CR wheels. With a standard lock nut I'd go with 35mm long bolts.

 Didn't think to mention it but it IS a CR front end!  Whew, thanks!

Share this post


Link to post
Share on other sites

I had a total brain fart. I was looking at the sprocket mounting bolts. :o

99% sure the front rotor mounting bolts are M6 low profile hex bolts. I doubt you will find them at a hardware store.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×