Jump to content
Sign in to follow this  

torq help

Recommended Posts

I am reinstalling cylinder studs.  The cylinder was sent out for redoing the bore.  The studs are reaching the torq limit (10 ft/lbs) before reaching bottom.   They are too high.   I tried cleaning out and driving them in and out a few times.  Any help would be great.

Share this post


Link to post
Share on other sites

 anti seize, and tighten till they bottom out. 

Edited by Fasz Kalap

Share this post


Link to post
Share on other sites

If you have to pick up a tap and die the thread sizes are written in the beginning of the service manual

thank you,

 

8mm * 1.25 ... 

 

worked great

Share this post


Link to post
Share on other sites

Just a thought.

 

Be careful in running a tap through stud bore holes.

 

The bore may be a close fit thread type to hold the stud in place and prevent loosing from vibration.  If you are not sure ... don't do it until you have researched it and are confident you can do it.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×