Jump to content
Sign in to follow this  

Fork leg guards

Recommended Posts

I've looked around and haven't found any that suit me, so I'm in the process of making plastic fork guards, similar to what inverted forks have, but for the upper part of the leg of course since we have conventional style forks. I have seen the integrated number plate/ fork guards that cycra plastics offer, and that acerbis offered for RM's but they are both number plates, and I'm wanting to retain my headlight. I'm figuring on taking some .062 inch thick black ABS plastic, and heat-forming it into a tube, that will fasten via clamps to the stanchion just above the lower triple clamp. Have any of you guys ever made something similar, seen something similar, or seen a commercially available product that I haven't seen? Thanks in advance.

Share this post


Link to post
Share on other sites

CFC makes some fork gaurds :)

Are they in the thumpertalk store? Where can I see some? Thanks.

Share this post


Link to post
Share on other sites

Deman, those are for the lower leg [slider]. I'm talking about the upper leg [stantion], that part which is normally covered by the rubber booties on a DRZ.

Share this post


Link to post
Share on other sites

ren you been under a rock?

under a rock, and had my head up my ass! Thanks Eddie! :)

Share this post


Link to post
Share on other sites

Eddie, questions: Did you trim those guards to that width, so that they only cover the front of the leg? Did they use to be closer to a full diameter? Did you have to fabricate any mounting hardware?

I did a search in the ktm forum under fork guards, but didn't get to many leads.

Share this post


Link to post
Share on other sites

do a search here for ktm fork guards.no trimming,near direct bolt on.you have to wrap a few winds of electrical tape for the bottom guides to fit tight.

Share this post


Link to post
Share on other sites

pm drew,he has the part numbers

Yep, PM me with your email addy and I'll send you a copy of the invoice along with some close-up pics of what I had to do to make it fit the S model. :)

Share this post


Link to post
Share on other sites

I like how that looks. If I ever replace my headlight, I'll definitely consider one of those. I wish I would have seen that pic before I ordered and installed the headlight on my KDX. I would've put one of those on it for sure. :)

Share this post


Link to post
Share on other sites

I allready have seal savers on the bike. I'm looking for some protection from roost and the occasional " I feel like flinging my bike onto some rocks!" scenario.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×