Jump to content
Sign in to follow this  

Rm 125 engine break in...but bike won't idle need help

Recommended Posts

I'm doing the 3 heat cycle ..but my thing Is that my bike won't idle with out me holding the gas a little bit I got top&bottom rebuild btw. Will that hurt the bike by any means if I'm holding the gas a little bit just so it won't cut off ? I'm not revving it really just hold and a few blips

Share this post


Link to post
Share on other sites

I'm doing the 3 heat cycle ..but my thing Is that my bike won't idle with out me holding the gas a little bit I got top&bottom rebuild btw. Will that hurt the bike by any means if I'm holding the gas a little bit just so it won't cut off ? I'm not revving it really just hold and a few blips

 

Do they allow dirty dirt bikes in DC??  Lol

 

It shouldn't hurt to blip very lightly when breaking in the bottom end, the 3 heat cycle is the right way to do it.   Your idle problem is a carburetion issue.  If I were in your shoes, I would have a friend blip the throttle lightly for you, then you can be free to adjust the idle screw appropriately.

Share this post


Link to post
Share on other sites

Not really no lol . But where is the idle screw ? I think it's the same knob as my choke . 99 bike with 02 engine

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×