Jump to content
Sign in to follow this  

CR 250 cylinder base check for '030 machining

Recommended Posts

For anyone interested in finding out if your 2005 - 2007 CR 250 cylinder has been previously machined, here is an easy check;

 

There are 4 small casting holes in the cylinder base.....these are approximately '030 deep and disappear to almost nothing when machined.

 

The pic below shows the stock 2007 cylinder on the right with the 4 small holes still visible.......and the machined cylinder after '030 has been removed.post-368409-0-21773900-1382610794.jpg 

  • Like 2

Share this post


Link to post
Share on other sites

For anyone interested in finding out if your 2005 - 2007 CR 250 cylinder has been previously machined, here is an easy check;

 

There are 4 small casting holes in the cylinder base.....these are approximately '030 deep and disappear to almost nothing when machined.

 

The pic below shows the stock 2007 cylinder on the right with the 4 small holes still visible.......and the machined cylinder after '030 has been removed.attachicon.gifpost-368409-0-21773900-1382610794.jpg

Thank's for the info, very helpful,  and TT should be sure this get's PINNED !!

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×