Jump to content
Sign in to follow this  

Piston and cylymder help

Recommended Posts

Ok so i rebuilt it and its had no compression and i just took it apart and i looked at the piston it was bent/curved inward in some places im not sure if i can just get a new piston or will i have to resleev it scence its bored 60 over this is a rm80. One curve is bye the arrow if you look close. Help me.

1400197436856.jpg

1400197448724.jpg

Share this post


Link to post
Share on other sites

So what you are saying is that your bore is out of round in one or several points or spots. 

If thats the case then it wlll need to be replated, or buy a new cylinder or sleeve it. 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×