Jump to content
Sign in to follow this  

07 kx250f idling and bottom end power

Recommended Posts

Te packed my exhaust and now wants to stall out at idle or I turn it so it doesn't stall but then it's too high, no happy medium, tongue curve is drastically different.

This normal?

Repacked*

 

No, it isn't.  You need to replace the copper gasket (washer) from head to head pipe and make sure the mid-pipe joint is sealed.  The bike should run better after re-packing, not worse, but if you install the exhaust incorrectly it will run much worse.  

Share this post


Link to post
Share on other sites

No, it isn't. You need to replace the copper gasket (washer) from head to head pipe and make sure the mid-pipe joint is sealed. The bike should run better after re-packing, not worse, but if you install the exhaust incorrectly it will run much worse.

Well it used to pop a lot before repacking on decal now it is not as bad I know where it slips on that gasket or what ever you call it is shot but it was before repacking too.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×