Clutch still slipping after rebuild

[Jremeee]

Road it tonight.. Still seems to be slipping a little but not much.

The clutch engages right before the handle is all the way out.

[bmwpowere36m3]

You need a little freeplay in the lever to insure the clutch fully engages with changes in engine operating temp and handlebar position. Adjust in a little more freeplay at the lever, I aim for about a nickel's width between the perch and lever.

[aclfish]

One fiber disc is different inner diameter cause of the spring being there first then the rest are the same size soak those fibers in oil for :10 minutes then instal fiber metal fiber metal. If it still slips when adjusted properly then your basket and pressure plate are worn out, so try putting a double old fiber in there to tighten it up! I did this on an old 1985 suzuki lt 230 and it worked like a charm. But getting neutral was a bitch if stopped. And it would slap the chain too. But it worked.

[jaybrds]

My bike did this and all I did was tighten the clutch up on the handle bars...