Jump to content
Sign in to follow this  

2008 rmz250 HELP RACING SOON

Recommended Posts

Okay so my bike backfires bad and I know that cause the valves need shimmed but at the same time if I set the idle to where it should be to idle perfectly when I'm riding I'll get off the throttle and my bike will keep going for a couple seconds more. I recently lost the red aftermarket screw that went into the carb underneath I think it's a jetting needle? And my bike wants to die while it's running. But I can keep it going fine on a track. PLEASE HELP ME THANKS EVERYONE

Share this post


Link to post
Share on other sites

Yes for sure the problem it's the air fuel mix screw had it fall out my 07 would not idle pop like hell only run have ass unless wfo

Share this post


Link to post
Share on other sites

Yes for sure the problem it's the air fuel mix screw had it fall out my 07 would not idle pop like hell only run have ass unless wfo

Okay that's great to hear! Won't cost much at all. Do you know how far it goes in? I think I jst didn't have it in enough and it vibrated out

Share this post


Link to post
Share on other sites

I can't remember I have a 2013 now but I think I screwed it all the way in and backed it off to half But not real sure been a while. Sorry

Share this post


Link to post
Share on other sites

I can't remember I have a 2013 now but I think I screwed it all the way in and backed it off to half But not real sure been a while. Sorry

Hey that's okay!! Thanks for the help man

Share this post


Link to post
Share on other sites

I have one laying around. pm me your address. i will send you that red screw. I'm never gonna use it again selling my 08.


Hey that's okay!! Thanks for the help man

1.5- 2 turns out is where you wanna be roughly. 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×