Jump to content
Sign in to follow this  

2003 Yz 125 rebuild

Recommended Posts

So far pretty much stripped it down. Got parts in today cylinder looks good not sure how important honing is but I should probably pick up one.

1406850321378.jpg

1406850360337.jpg

1406850370938.jpg

Share this post


Link to post
Share on other sites

Got some time today finished the top end, radiators, carb, and got the shock and linkage greased and installed. Ofc a ton of scrubbing the years of crap off the parts, still a ways to go.

1407119046400.jpg

1407119062845.jpg

1407119082018.jpg

1407119114522.jpg

Share this post


Link to post
Share on other sites

What do you use to clean the frame? Also, I know a lot of people powdercoat their frames but is there any other type of paint that can be used? Something that is kinda durable? I have a 2002 Blaster that I am rebuilding but I am on a budget. I would rather spend the $$ on performance rather than painting the frame. Thanks!

Share this post


Link to post
Share on other sites

Scotch bright pad and soap for the frame I wanted to powder coat but kinda expensive and I'm not sure about the paint.

Share this post


Link to post
Share on other sites

All finished carb had a bad seal was in the float valve. Took a old one from my 250f that I had extra was a tight fit but works fine, cranked it up rode around a little runs good compression is high. Got to work on the jetting its jetted for sea level and I'm at 6500 feet. Time to ride tomorrow.

1407290805239.jpg

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...