Jump to content
Sign in to follow this  

Recommendation for OIL RESISTANT EPOXY.

Recommended Posts

I have to fabricate a fitting for the oiling system on a vintage bike and I need to epoxy a banjo fitting together.  I'd solder it but I'm afraid I might ruin the fitting - It's pretty small.  Its the oil injection line so there's no pressure involved.  I see a Loctite product that would fill the bill but I can't find anyone close to me that stocks it and I need it before the end of next week.  Has anyone used J-B Weld for something like this?  At least someone stocks it near me.  Any other suggestions?

Thanks.

Share this post


Link to post
Share on other sites

since I didn't get any answer quickly, (i'm pressed for time on this one) I soldered the parts.  I was VERY careful but brass to brass is an easy solder.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...