Jump to content
Sign in to follow this  

01 cr250 power valve?

Recommended Posts

Your power vavle is jammed half way open from shows in the picture.

Share this post


Link to post
Share on other sites

If you had cylinder work done its common theirs insuffient clearance for the valve to close.

Share this post


Link to post
Share on other sites

The owners manual said it will close after starting but now it's still half way open. What is the best way to get it to close without taking the tops end off?

Its either being restricted by the cylinder bore, or the powervalve vertical shaft that runs down to the case isn't connected properly to the keyed actuator. Thats actually common. You can put the cylinder on and not realise it needs to be lined up and seated first. Either way you taking the cylinder back off or at least popping it up a couple inches to check alignment.

Share this post


Link to post
Share on other sites

Its either being restricted by the cylinder bore, or the powervalve vertical shaft that runs down to the case isn't connected properly to the keyed actuator. Thats actually common. You can put the cylinder on and not realise it needs to be lined up and seated first. Either way you taking the cylinder back off or at least popping it up a couple inches to check alignment.

^^^^this

It is very important to ensure the shafts are aligned and set up properly when you slide on the cylinder.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...