Jump to content
Sign in to follow this  

After rebuild, bike won't shift into 4th and 5th

Recommended Posts

Okay after splitting the cases, replacing bearings, seals, crank. Basically everything but tranny. Put it back together, lined the shift forks and such back according to the service manual. My only thought is that because the shift pawl fell apart, I might have put it back together wrong or at an odd angle. What are some potential issues as to why this is happening? I didn't replace a single thing tranny side

Basically when you go to shift into fourth, it almost feels like it's going to shift then just revs like it's in nuetral. It's hard to explain. Oh it's a 03 rm250

Share this post


Link to post
Share on other sites

When the case was actually split, it was rough shifting into 4th because the countershaft shift fork was getting caught towards the end of the shift but it would get into with coaxing. Figured it would shift with load on it.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...