Jump to content
Sign in to follow this  

Cr125 forks?

Recommended Posts

Hello everyone, so i cant figure out why my bars look bent. In the picture you can see the fork bleeder screws are in different spots and i dont know how to fix it. I even tried a pair of new bars on and it looks the same so the bars arnt bent. Any suggestions?

1408569642673.jpg

Share this post


Link to post
Share on other sites

It's most likely the rubber bushings in the top clamp. Replace them and see if that does it.

Share this post


Link to post
Share on other sites

If you are talking about the bleeder screws,just loosen the triple clamp bolts up a little bit (top/bottom), enough to twist the tubes and bleeders to your desired spot. Then torque the bolts back to spec. The handlebars usually straighten after loosening and then torque to spec the clamp nuts in the underside of the top clamp.

Share this post


Link to post
Share on other sites

I changed the rubber bushings on the top and bottom so ill try twisting the forks, do you know what tge torque is for the triple clamps top and bottom are?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...