[[Template core/global/plugins/realFaviconGenerator does not exist. This theme may be out of date. Run the support tool in the AdminCP to restore the default theme.]] Jump to content
Sign in to follow this  

Front Sprocket Lock Washer Bend Tab

Recommended Posts

Haha fingers....

 

My vice grips don't grip the edge of the washer. I'm thinking they are just too small. The Screwdriver just flexes and digs into the sprocket.

Edited by u83AAf3

Share this post


Link to post
Share on other sites

Haha fingers....

My vice grips don't grip the edge of the washer. I'm thinking my are just too small. The Screwdriver just flexes and digs into the sprocket.

You can do it Forrest. You can also pre bend it. Edited by stevethe

Share this post


Link to post
Share on other sites

Use a hammer and a wood chisel to get the bend started, then cold chisel, then a blunt object, like a tire iron and a hammer.

 

If you use just a screw driver, you usually just end up cutting the tab so it will start to crack, unless you are careful.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×