Jump to content

NEED HELP AGAIN SORRY GUYS IM NEW HERE!


Recommended Posts

Hey so here is my problem, I have a kx250.. I put back together with all the running gears.. I used c clamps to put the case back together. When I put the 2 halfs back together and start putting the screws in and tighten near the chain gear. and the transmission locks up and the crank shaft gets really tight.. Any ideas what it could be?

Link to comment
Share on other sites

something is not right in there.

 

the cases should slide together without the use of c clamps, at the very most a few tap's with a dead blow or rubber mallet....and lightly.

 

follow the manual and make sure everything is where and how it is supposed to be.

Edited by Excitable
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

×
×
  • Create New...