Jump to content

swingarm seals


Recommended Posts

ok so quick one really ive pressed the bearings in and im about to put in the seals and washers etc i know the washers go in first bu then i have two sets of seals one that is metal rimmed the other is just rubber from what it looks like i just use the metal rimmed ones as the other rubber ones are not on the parts fiche. should i use them both or what?

thanks in advance guys.

 

bought 135.JPG

 

bought 136.JPG

this is the rubber seal i dont think i need to use

 

i should add that im fairly certain that no rubber seals came out when i took out the bearings bu that was about 3 weeks ago and i have been busy since then and cant remember. but of the old parts that i collected they aren't in there

Edited by tumbiri
Link to comment
Share on other sites

this is a screen shot of the fiche

 

l;cdd;.png

 

8. is the shaft seal bucket

9. is shaft seal the metal one

12. is the stop washer

 

its possible that the fiche is wrong i just dont want to not put them in and reassemble and have to put them back it etc.

the kit comes with four of these rubber seals btw

Link to comment
Share on other sites

i ended up not putting in the rubber seals did some measuring with the micrometer and there was not enough clearance for the seals to fit in as well so i couldent put them in there anyway it does see odd that they were even supplied but oh well.

 

those seals are a bitch to get to seat in so they go in flush. 

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

×
×
  • Create New...