Jump to content

fmf 4.1 small issue


Recommended Posts

I just got my new fmf factory 4.1 stainless slip on for my 2014 yz250f, but it seems to fit a little snug. the bottom bolt lined up fine but the top bolt on the muffler didn't. It did go in but I had to put a little upward pressure on the muffler to get the hole to line up. not a serious amount of pressure but more then I like to see and I cant seem to adjust anything to line it up. Has anyone else experienced this? I cant imagine its normal, just don't want to crack my new pipe!

Link to comment
Share on other sites

Well I loosened everything and it did fit quite a bit better. Had to do a lot of jiggling but it finally went into place, there wasn't any extra play tho the top bolt on the silencer just lined up. I'm thinking I'll do a top end before spring so I'll get to mess with it more but I think it's as good as it'll get. Looks sick on there! Now if the snow would get lost!

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

×
×
  • Create New...