I have a 2007 450 EXC that I recently installed a new clutch slave cylinder on. Per the 2007 KTM service manual it clearly states that the clutch needs to be filled with hydraulic oil, which I did (magura blood). That was yesterday. I went out to double check the level today and when I removed the cover, the rubber seal was all contorted and out of shape. I then looked at the cover and it's a Brembo clutch and says "DOT 4 brake fluid only".
I flushed the line and the master cylinder about 7 times with DOT 4 brake fluid and there was no sign of the magura blood left in the system. My question is: other than the rubber boot on the master cylinder, what damage might have been done by putting in the hydraulic oil? It was in for about 24 hours.
Thanks in advance for any advice!
By Charles Mrizek
This replaces the tube that connects the two carbs on a 1987 Honda XR600R (it may fit other years).
Made in the USA.
Constructed of TPU (solvent safe plastic.)
Its durable stiff abrasion resistant yet flexible enough you never have to worry about breaking it when you're taking apart your carbs.
Fits the o-ring perfectly and slips into the carb nice and tight.
Matches the rear shock coil.
If you would like to buy one contact me via e-mail. They cost $40 Shipping is free (anywhere in the USA). $10 off for active duty or retired military.
Make your subject: XR600r
By KX290F Pilot
THIS WAS MOUNTED TO MY 2015 HUSQVARNA TC250. I PURCHASED A FACTORY HUSQVARNA UNDER BAR MOUNT STABILIZER SO I DON'T NEED THIS ONE ANYMORE. THIS STABILIZER FITS UNDER YOUR NUMBER PLATE OUTTA SIGHT. GREAT FOR THE MOTOCROSS OR OFF ROAD RACER THAT WANTS TO KEEP THE FRONT END A LITTLE LESS TWITCHY. HELPS YOUR ARMS NOT GET ARM PUMP AS FAST. THIS IS THE SAME DAMPER YOU SEE ON HONDA MOTOCROSS BIKES (CRF) HAS ADJUSTMENT KNOB SO YOU CAN ADJUST THE AMOUNT OF DAMPING YOU NEED AT DIFFERENT TRACKS. THANKS FOR LOOKING. GO TO THIS EBAY PAGE FOR FITMENT TO YOUR MOTORCYCLE: https://www.ebay.com/itm/263512002497?ViewItem=&item=263512002497#vi-ilComp