Jump to content
Sign in to follow this  

SMC 690 Filter Issue

Recommended Posts

I have an '08 SMC 690, I've owned since new. Recently, I bought a K&N filter for it, and after putting in on, started getting a FI flash on my dash. 9 flashes, indicating a "Input signal from pressure sensor of induction manifold too low/high. I'm assuming it's because the filter is flowing more air, but I'm wondering what to do about it.

I have a Dynojet Power Commander on it, that's been working great, since I installed it, so I have plenty of mapping possibilities. I was hoping someone out there in Thumpertalk Land has seen this issue, and could offer solutions.

When I put the stock filter in, the FI flash goes away immediately.

Thanks for any input.


Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

  • Create New...