Jump to content
Sign in to follow this  

How to break in Cr 250

Recommended Posts

In my personal experience I did the following.

1- from first start up I let it warm up 2-3 min then ride gently with 1/4 throttle bursts 10-15 min let cool completely.

2- again let warm up, 10-15 min 1/2 throttle bursts let cool.

3 after warm let the engine sing and enjoy what we all love-- the sound of a 2stroke at full noise.

Share this post


Link to post
Share on other sites

Divisive subject so i will differ from John... warm up, then ride it like you stole it.

Share this post


Link to post
Share on other sites

2 heat cycles then recheck the bolts/nuts. Forget it was rebuilt and ride.

Share this post


Link to post
Share on other sites

Hello i have 2005 Cr 250 with bottom and top end. I want to know the best way to break in process.

Ride it easy for 1/2 hour.  Let it cool down, re-torque head & cylinder bolts.  Rip on it !    :thumbsup:  :ride:

Edited by Throttle5

Share this post


Link to post
Share on other sites

0.jpg3 heat cycles, 3 cool down periods, my view is differing than the rest. I would take it easy for the weekend of riding, after the 3 cycles, you very could clean the chrome off that cylinder.......so take er easy! The next weekend begin your riding with small burst of power band.  Then later on in the day, let er rip!!!

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...