Jump to content
Sign in to follow this  

2016 FE 350 brake light

Recommended Posts

I'm new to the forum but have been reading posts for a few years I have a 2016 FE 350 and want to put the brake light pressure switch on. On my other KTM bikes I had to replace the tail light assembly because there was no lights.  This bike has a tail light that for some stupid reason they made it to work as a running light.  Has any one else done this mod I want to avoid replacing tail light with the 350S unit. Any help or advice would be appreciated.

Thanks,

Bob 

 

 

Share this post


Link to post
Share on other sites

I picked up the Sicass racing rear brake switch installed it and it plugged into the wire harness without any splicing required.  It turned rear LED running light into a brake light.  What I was wondering is if any one has done this mod how did they route the wires.  I am trying to avoid the exhaust pipe while I avoid drilling or cutting the airbox/subframe. Any help would be appreciated please include photos if possible.

Thanks

Share this post


Link to post
Share on other sites

I ran it inside the subframe then on the outside of the frame... works good so far

 

 

Sorry took a bit on the pic

Same as I did on our FE250.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...