Jump to content
Sign in to follow this  

Pesk crank bearing retaining torx screws

Recommended Posts

I use a heatgun to loosen the loctite then a torx bit on a ratchet. Never had a problem getting them out that way.

Share this post


Link to post
Share on other sites

Hey if you remember.. Im up to installing clutch n kickstart stuff.. All looks good.. Just one question.. Idk if u can remember.. The kickstart gear n the idler gear.. When the gears mesh. It seems there not totally meshed even.. Hard to explain.. But where they mesh one gear is in the middle of the other gear.. Not totally even.. Maybe cause case is laying on its side.. Ive double checked install.. Using

Manual. And all correct. You got any input..

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...