Jump to content
Sign in to follow this  

DR650 All-Balls wheel bearings seals ?

Recommended Posts

kind of an odd question..

I'm replacing my rear wheel bearing with NEW All-Ball Racing bearing and seals. 

 

My question is, after I press in the bearing on the non-drive (brake side) there is NO room for the dust seal.. as if the bearing is too thick, however, I check my old bearing and they are the same size. YES, I have the new bearing pressed ALL the way to the bottom.

more information.. I removed the new bearing and measured the bore with calipers and then measured the bearing and seal together.. once again, the seal will NOT nit after I press in the new bearing.  

 

any advice?

 

thanks in advanced.

 

 
dr650 rear wheel.JPG 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...