Jump to content
Sign in to follow this  

Are the lycra power flow kit the same as the OEM plastics on a 2013 KX250F?

Recommended Posts

want to know if i buy a set of graphics for OEM 2013 KX250F plastics will they still fit on Cycra power flow plastics, any help would be greatly appreciated. 

Edited by OLIVER132

Share this post


Link to post
Share on other sites

Cycra power flow rear fender is a little different where it meets the seat. It has a little intake port going into the airbox. The port goes about 2 to 3 inches out towards the end of the bike. Fitting graphics onto this port takes a little patience with a razor knife and heat. But it's definitely not a show stopper. Other than that, applying graphics to these plastics is the same as any other kit. 

Share this post


Link to post
Share on other sites

Front number plate is the same. Shrouds are the same but the powerflows have an extra lip at the top that will show above your graphics.

Share this post


Link to post
Share on other sites

Have you got them on your bike? if so could you send a couple of pics so i know what it is going to look like.

Share this post


Link to post
Share on other sites

Haven't really had my bike out but once. I'll try to get some this weekend.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...