Are the lycra power flow kit the same as the OEM plastics on a 2013 KX250F?

[OLIVER132]

want to know if i buy a set of graphics for OEM 2013 KX250F plastics will they still fit on Cycra power flow plastics, any help would be greatly appreciated. 

Edited January 25, 2016 by OLIVER132

[pCp 450]

Cycra power flow rear fender is a little different where it meets the seat. It has a little intake port going into the airbox. The port goes about 2 to 3 inches out towards the end of the bike. Fitting graphics onto this port takes a little patience with a razor knife and heat. But it's definitely not a show stopper. Other than that, applying graphics to these plastics is the same as any other kit. 

[OLIVER132]

So are you sure the front plate and shrouds the same? thnx for helping mate

[DCBmx119]

Front number plate is the same. Shrouds are the same but the powerflows have an extra lip at the top that will show above your graphics.

[OLIVER132]

Have you got them on your bike? if so could you send a couple of pics so i know what it is going to look like.

[DCBmx119]

Yes, I have a full cycra kit, I will post pics tonight.

[OLIVER132]

Are you still able to post some pics?

[DCBmx119]

Haven't really had my bike out but once. I'll try to get some this weekend.

[OLIVER132]

Haven't really had my bike out but once. I'll try to get some this weekend.

Thnx mate

[OLIVER132]

Hi just wondering if you can still put up some pics.