Replacing crank bearings, locking tabs

I'm doing this 2006 wr 450, replacing all bearing after lubrication failure. I see that the main bearings have a special screw that's been indented for security. How do I go about removing this? I know the tabs will be chewed out if I just go for it and the screw drive could potentially looks too thick of an edge to bend back up? Are the screws and tabs one time use parts? Any insight appreciated! Thanks ImageUploadedByThumper Talk1470357125.586815.jpg

I just put a torx socket on a 3/8 impact and go to town-

For some reason your question is not visible.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now