Jump to content

Recommended Posts

So I took my carb off to clean it and replace needle seat . Made sure all the circuits were clear. Now, runs fine with choke on down to one fourth choke . After that, it spits and spotter's and pops in the carb.

 

I put new fuel in it. It has a new plug. I've taken this carb down twice now and check to see if I installed something incorrectly. I am stumped at this point it ran fine before, any suggestions? It has to be something I did or didn't do, I have triple checked every component, everything seems to be correct. Signed, pulling my hair out!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:


×