Jump to content

88 RM 250 Swingarm Bearings

Recommended Posts

Was wondering if anyone knew the proper depth to sink the swingarm bearings into the round pivots? I have two separate swingarms on hand and both had different measurements of the old bearings. I glanced at the manual but didn't notice any specs for this.

 

If someone can point me in the right direction so that all the pieces in the rebuild kit will fit as they should, it would be appreciated!

Share this post


Link to post
Share on other sites

Press the old bearings in enough for the oil seal to sit flush with the swingarm

 

RM.png

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:


×