Jump to content
Sign in to follow this  

How worried should I be about this?

Recommended Posts

Getting ready to replace some bottom end bearings and found this...20170607_195643.jpg

The part of the case that will meet the outer racing of the bearing has a bit of a gouge in it. What should I do? Sand paper or am I boned?

Share this post


Link to post
Share on other sites

LIGHTLY sand any raised areas then clean and install as normal.  You're only screwed if the bearing ISN'T a press fit...

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...