Jump to content

Master Cylinder Rebuild

Recommended Posts

I had to rebuild mine after a crash couple months ago. Stripped out the receiving end where the banjo goes. Then found a pin hole in the gasket of the actuator body. So I replaced that. And I'm not sure if imagining it but it almost seems like a smoother shift now. Mine wasn't all that bad but it feels a little easier now

Share this post


Link to post
Share on other sites
I had to rebuild mine after a crash couple months ago. Stripped out the receiving end where the banjo goes. Then found a pin hole in the gasket of the actuator body. So I replaced that. And I'm not sure if imagining it but it almost seems like a smoother shift now. Mine wasn't all that bad but it feels a little easier now

Where did you get the parts from?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:


×