Jump to content
Sign in to follow this  

2003 Honda CR125r exhaust valve bearing

Recommended Posts

Hi there! I have a 2003 CR125r that needed an engine rebuild. I wasn't thinking when I tore the motor apart and misplaced the exhaust valve bearing.(the bearing on the cylinder)  It appears to be NLA from Honda for some time. I was hoping someone had the part number so I might find it NOS or at least the dimensions so I can get from a bearing supply company. Or any other ideas. 

Thanks in advance.  

Share this post


Link to post
Share on other sites

#16 correct? Strange that it's not listed as available. I could try to get measurements with my calipers tonight after work when I get home if you need them and can't source a comparable size. Not sure on the bearing part number S.O.A.N.Z listed as the numbers in parentheses seem to be in mm and sounds awfully large. Looking at the microfiche for the right side case where the waterpump shaft bearing resides lists bearing:

BEARING, RADIAL BALL (7X19X6) (NTN)

91002-KA4-003

 

7mm ID x 19mm OD x 6mm wide is how I would read that.....the 19mm part is what throws me off. I can't imagine that bearing being that large in diameter sitting here thinking about it.

 

CR125-RC-Valve.jpg

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...