Jump to content


Recommended Posts



I was out riding in New Jersey and I looped out on my bike. I picked my bike back up only to realize my FMF Factory 4.1 Exhaust slip on was severely dented. I have a few ideas i'm not so sure if they'll work. I thought maybe somehow I can creat a water tight seal and freeze the water inside to maybe pop

the dent out. Or maybe i could heat it up and pry it back to shape from the outside. Don't know if i should take it apart and bang it back to its original shape or not. All suggestions welcome. Thank you.

Share this post

Link to post
Share on other sites

Wow, nasty dent. Hope your ok.
I would send that photo directly to FMF headquarters and ask their advise(email).
It's rivited on both ends so a bit more difficult to open. I'm guessing it will be a write off, sorry. Good luck, G.

  • Like 1

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with: