Jump to content

Help with clutch push rod and slave cylinder

Recommended Posts

So I had to work on my 2005 Husqvarna tc250 clutch... While the clutch components and clutch push rod were out, the clutch lever got pulled in.  When I put everything back together, the clutch push rod doesn't go in all the way. It's about 5-7mm out.  Does this mean that the clutch slave cylinder piston came out and now won't allow the pushrod back in?  If so, what do I do?  Do I have to take the slave cylinder off and push the piston back in?  Or will the pushrod get pushed back in if I try to finish putting on the pressure plate and springs?

 

Thanks

Share this post


Link to post
Share on other sites

Thanks.  I took the slave cylinder off and then reassembled the clutch and pushrod and then put the slave cylinder back on. I think I'm all good, but haven't gotten a chance to test it but the clutch seems to be working.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:


×