Jump to content

Labor costs?

Recommended Posts

What might I expect to pay to install FMF full exhaust, a fcr 39mx carb, hotcams intake/exhaust, New plastics headlight/tail light, 3x3 mod, k&n air filter, and jd jetting? I live in the greater Washington Metropolitan Area. Labor cost runs from $75-$100/hr

Share this post


Link to post
Share on other sites

Wow you sure are excited about this build...

That is a question for the service department. And use a Uni or TwinAir, not K&N.

Share this post


Link to post
Share on other sites

I'm not the most gifted man in the garage but even I could do all of those but the cams. Might even give the cams a shot if I was feeling daring. I say get some tools, watch a couple youtube videos and go for it. Worst case you screw up and need to take it to a shop anyway. Good Luck!

Edited by Wily

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:


×