need your expert help please....

[gixxerfever]

so i had two different brake set ups a moto master, and then decided to buy the braking set up. i was told that the braking set up would work with the stock 426 master cylinder. so i was putting thing on i bled the brakes for about an hour and guess what? nothing, so i pick up the phone and call braking... and guess what? now they tell me it won't work with the stock master.... so here's my dilemma, does anyone know if i can mount a gsxr master and make it work? also as i mounted a rear rotor i noticed that it rubs against the ins in the caliper i sthis normal??? i'm going nuts.... thanks....

[RAD]

Moto Master works with stock 11mm but best with 13mm

Braking works best with 16mm or 5/8" will not work with stock.

[Motodisiac]

The reason your rotor is rubbing in the back could be that Yamaha changed to 5mm bigger disc in 2002, so if your bike is 2001 or older it needs smaller disc.

[gixxerfever]

The reason your rotor is rubbing in the back could be that Yamaha changed to 5mm bigger disc in 2002, so if your bike is 2001 or older it needs smaller disc.

damn it..... back to stock disk then..... ?

[jtc89]

Yes you can use a GSXR m/c. I used one on my BRP that has a Braking caliper and rotor. The one I got was from a GSXR1K and was a 5/8inch diameter. It works great. Feel and power are fine. On a BRP you can get one finger stoppies, so on a 426 you can really stop.

TC

[RAD]

It all depends what you like too, I use a 14mm on the MotoMaster off of a R1 but I doubt you would like it because it is stiff - really stiff.

[Wayward Son]

i use a 14mm honda vtr1000 master on motomaster set up.like rad says,its stiff.but it works damn good!

[gixxerfever]

cool, i have a gsxr from my other race bike so i'll throw that one on, does anyone know where i can buy a single line banjo bolt for it???