Kill switch connection

[Protip]

I have a 2012 KX450 and am going to ride it in an event where I have to put a tethered kill switch on it. After doing some testing I got a normally open tethered kill. It just has wire coming out of it though. Does anyone know where I can get the connector that would plug directly into the spot the factory kill plugs in so I could just swap it in and out as needed? Picture is of the female side that it needs to plug into. The male side is hanging next to it.

[jevyguy]

I don't know which one you need but this place should have it

http://www.cycleterminal.com/mt-series-090.html

[skorpan777]

On 9/11/2017 at 9:37 PM, jevyguy said:

I don't know which one you need but this place should have it

http://www.cycleterminal.com/mt-series-090.html

Never seen this page before but it is exactly stuff thats a save for future.

Thanks