Jump to content

Ktm open chamber fork preload

Recommended Posts

I've read that ideally you want 5mm of preload, when I installed new springs my preload is just over 6mm with the preload adjuster on the fork back off. Should I remove a washer to decrease the amount and then fine tune with the adjuster on the fork cap? Thanks

Share this post


Link to post
Share on other sites

You must keep a washer on to allow the spring to rotate

Share this post


Link to post
Share on other sites

Right now I have the thinnest washer installed and the preload turned 2 times to give me roughly 5mm, is this correct or should I put both washers back on?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:


×