MxGringo Posted November 4, 2017 I removed my tps not knowing you actually need the fi diagnostic tool to set it correctly. Is there any given standard voltage i can adjust it to? Read in an old thread 0.65 V. Can anyone verify? Manual only refers to adjust using the fi tool. Share this post Link to post Share on other sites
KRAYNIAL My Rides (3) Posted November 5, 2017 Yes, all the Keihin systems use a TPS voltage of around .55 volts. The small range of voltage is for advancing the map a bit. You must apply voltage to the TPS to make the measurement. http://www.yfzcentral.com/forum/86-yfzr-x-powertrain/253185-adjusting-tps.html Share this post Link to post Share on other sites
MxGringo Posted November 5, 2017 Yes, all the Keihin systems use a TPS voltage of around .55 volts. The small range of voltage is for advancing the map a bit. You must apply voltage to the TPS to make the measurement. http://www.yfzcentral.com/forum/86-yfzr-x-powertrain/253185-adjusting-tps.htmlGreat link. ThanksHow many amper do I need for this? Share this post Link to post Share on other sites
