Jump to content

YZ250X Seal Housing

Recommended Posts

Hey guys so today i went for a ride and ended up with a flat rear when i came home i had noticed the seal was out a little bit upon further inspection it looks like this 

I can push it back in but comes out again really easy, Bike only has around 70hrs

Looks like a small job for replacement but just wondering should i replace the gasket thats there aswell ?????? Witch is part number 39 on parts diagram photo

I have no idea how this could have happened 

 

Thanks

 

cyl-head-2.jpg

cyl-head.png

Share this post


Link to post
Share on other sites

Might not have been installed properly after a top end rebuild.

Just take the plate off and put it back in if it’s not damaged.

Replace if damaged but don’t worry about the gasket.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:


×