Jump to content

99 cr250 power valve not workimg

Recommended Posts

Adjusted the power valve on my 99 cr250 and not the power valve won't move at all

I took the pin out of the top to clean the linkage up a little bit could the drive shaft have disconnected from the pinion shaft? 

15267709209541670337804.jpg

Share this post


Link to post
Share on other sites

Generally what happens is when the cylinder is put back on the cases no one pays attention and the crow’s foot on the drive shaft gets smashed by the pin on the pinion shaft. 

Share this post


Link to post
Share on other sites

Ok found the problem 

 

Someone wasn't paying attention when they connected the pinion shaft to the governor the pinion shaft was one tooth to far clockwise looking down onto the motor causing the drive shaft not to be able to move as far therefore not opening the powervalve

I'll post a video as soon as I figure out how... 

  • Like 1

Share this post


Link to post
Share on other sites

You are luck then, most of the time the shaft gets smashed and broken and it’s not cheap to replace or easy to find anymore. Glad you got it figured out, once you get the shafts working together the manual should walk you through how to set and adjust it. If you have anymore questions let us know. 

Share this post


Link to post
Share on other sites

 

Here's the video

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×