Matt Dial Posted January 13 Just purchased a 2016 kx450 and noticed the front sprocket cover area is damaged. My question is should I try and get bolts and cover back on there considering they are damaged on the engine? I don’t want to replace it and make it worse if it breaks off again and then really be in trouble. Here’s some pictures to help. Thank you Share this post Link to post Share on other sites
Confederate My Rides (2) Posted January 13 Ouch! Put studs in the hole after you clean and retap what is left of the threads. Bottom the studs in the hole with locktite then a little jb weld stick to replace the missing material. Use nuts to install case saver and trim studs flush. Otherwise new case side. Share this post Link to post Share on other sites
Trailryder42 Posted January 13 9 minutes ago, Confederate said: Ouch! Put studs in the hole after you clean and retap what is left of the threads. Bottom the studs in the hole with locktite then a little jb weld stick to replace the missing material. Use nuts to install case saver and trim studs flush. Otherwise new case side. +1 And check to see if the CS sprocket is oversize from what stock tooth count is. Share this post Link to post Share on other sites
BOAB Posted January 13 And buy a new sprocket nut lock washer. 😏 Share this post Link to post Share on other sites
Matt Dial Posted January 13 Ok thank you guys very much...I’m gonna order the bolts, case saver, and case cover now and take it from there Share this post Link to post Share on other sites