Jump to content
Sign in to follow this  

Weird problem... engine dies when you turn the handle bars to the Rt??

Recommended Posts

Has anyone seen this problem before? The engine will die just before the forks reach full turn, (about 1/2 inch before full turn is met). I've looked around the forks and there are no wires exposed or being pinched... just don't get it... Please help is ya can. Tks.

Share this post


Link to post
Share on other sites

try to pull your throttle cable out a little bit so it doesnt get pulled tight when u turn the wheel

Share this post


Link to post
Share on other sites

I would double check the kill switch wires (especially if you run tall bars) and the decompression lever cable (if you haven't done the 450 cam mod).

Share this post


Link to post
Share on other sites

I wouldn't mind betting your decomp cable doesnt have enough freeplay and it pulling your ex valve open when you turn your bars

Share this post


Link to post
Share on other sites

I would double check the kill switch wires (especially if you run tall bars) and the decompression lever cable (if you haven't done the 450 cam mod).

He's back!! (and he is correct.....)

Share this post


Link to post
Share on other sites

Yup, probably the decompression cable...when i tore my bike apart last year i had this coiled spring left over and couldnt for the life of me remember where it went. After my first ride every time i would turn the bars right, it would make this nasty sounding knocking noise and would die 9 out of 10 times....turns out that spring was what kept enough tension on the decompression lever at the head to keep it from engaging! :thumbsup:

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×