Jump to content
Sign in to follow this  

jumping WR250F settings ?

Recommended Posts

Help on settings

is the following information correct. i understand that i will need to do more expermenting i im only after general information this is what i think needs to be done after reading manual

Setting suspention from stock

front shock:increse comperession clikers (bottom clikers)

adjust rebound clikers so fork rebounds slower

increase oil level to prevent bottom out

rear shock:increase high comperresion adjuster to prevent bottom out

increase low comperresion cricker

adjust rebound to allow slower rebound

i am only want to know if i am on the right track

maybe revalve stiffer springs this would cost $$$

thanks

Share this post


Link to post
Share on other sites

I have done all this except the oil height. Its a major improvement except one huge table top im not quiet clearing and im defintely bottoming out front and rear. If oil doesnt help im gunna go spend a day at Race Tech who does full custo settings + teaches you how to do it all yourself for $800. Where in aus are you.

Share this post


Link to post
Share on other sites

I have done some expermenting i have found that the clikers on the front set 7 out is a little to hard i have set it 10 out this seems not too hard .Rear shock high comp set about half a turn in from stock.Ihave already set fork oil height

5mm higher.i still need to play with rebound front and rear.As i start jumping bigger i will do some more adjustments.Note this is on the aus model

david

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×