Jump to content
Sign in to follow this  

rubber seal on rear master cylinder

Recommended Posts

I was just out adjusting my rear brake pedal height nad as I spun the adjuster nut the rubber seal would just spin along with it. so I pushed the seal up past the 2 "rings" adjusted it then pulled it down again. The brake feels quite spongey now. Can air get into the system through that seal? And to prevent this from happening again, where is the proper place to seat the seal? Thanks.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×